The Rigid Restrike press was designed for both Sizing and Coining operations.
Normal sizing operations involve qualification or calibration of specific
part geometries or dimensions. A stiff rigid press structure is needed to
maintain precision during these functions. Coining operations involve further
densification of a part or putting additional features on the part.
This requires substantial force as well as accuracy. Rigid Restrike presses
are a well-guided, very stiff structure that was designed to provide long
reliable service either sizing or coining.
Rugged Robust Structure
The press uses an all steel welded construction tie rod design press
structure to handle the high impact loads developed during typical restrike
operations. The high modulus structure is important for accurate repeatable
part-to-part production.
Integrated Dial Feed Automation System
A servo controlled Dial Feeder provided as standard equipment automatically moves parts through the following stations:
Load Station (Optional Orientation Station)
Pre-Press Part Check Station
Die Cavity Pressing Station
Post-Press Part Check Station
Unload Station
Multi-Level Part Capability
The Rigid Restrike Press has available motions to provide independent adjustments
for the following part levels:
Outer Upper Punch
Inner Upper Punch
Shelf Die or Straight Die
Major Lower Punch
Outer Core Rod Punch
Stepped or Straight Through Inner Core Rod
CINCINNATI Press Control Center
Fingertip programmable computer control of press functions is provided by the
Press Control Center designed and built by CINCINNATI. The combination of Menu
Driven Software and Softkey Technology simplify set-up and operation to reduce
operator effort and ensure proper production of repeat production lots.
Lasers
